Location:
Search - LED effect
Search list
Description: 功能：读取按键,控制LED闪烁。
首先对引脚选择寄存器PINSEL赋值为0，设置引脚连接GPIO。,然后对按键进行扫描，等到有键按下时，开始LED闪烁的程序。为了使LED有各种各样的闪烁结果，对其设计了一个表LED_TBL[]，并不断调用，对P0[7:0]这8个设置为输出的I/O口进行置一或清零，得到花样流水灯的效果。当接P0.14的按键按下时，LED闪烁状态会回到最初全灭至亮状态，然后继续按照其他花式闪烁。
-Function: Reads keys, control LED flashes. First register PINSEL pin assignment to 0, set the pin connections GPIO. And then scan button, wait until a key is pressed, the program began flashing LED. In order to make a wide variety of LED flashing result, its design a table LED_TBL [], and continue to call for P0 [7: 0] This 8 is set to output an I/O port for a set or cleared get water lights pattern effect. When the button is pressed pick P0.14, LED flashing light will return to the original state all off, and then continue to follow the other fancy flashing.
Platform: |
Size: 72704 |
Author: 范鹏 |
Hits:
Description: 51小车程序运行效果：将小车置于一个桌面上(桌面请不要使用黑色)。打开电源的开关，小车开始前进运行，同时运行指示灯闪亮，这时如果前方有障碍物(或走到悬崖处)，小车将会先进行后退一段时间，并有蜂鸣器报警，再向左转一段时间，最后开始向前运行、左转、后退、右转、可以通过前方指示灯来观察。这时你可以能过声控(如拍手声)来让小车停止和开启.同时你也可以用遥控来控制小车的运行。按“1”，小车将向前运行，按“2”小车将后退，按“3”小车将左转,按“4”小车将右转.按其它(0-9)键，小车数管码显示相应的数字符号。按电源键，小车将会停止运行。同也可以用电脑将小车发送数字信号。其数码管也将显示相应的数字(0-9)。并执行相应的功能。当然S1、S2 也是起作用，分别用于控制小车的停止和开启。(注意：操作时应在小车前进时操作，后退、左转、右转等操作时，没有写相应的查询程序)-Effect of the running procedures 51 car: place car on a desktop (desktop do not use black). Turn on the power switch, the car started running, and running indicator light flashes, then if obstructions in front of (or over the cliff), the car will be going back for some time, and buzzer alarm, then make a left turn for some time, finally began running, turn left, backward, right, and can be observed through the front led. At this point you can have voice-activated (such as clapping) to make the car stop and start. at the same time you can also use the remote control to control the car s run. Press 1 , the car will move forward to run, press 2 car will be back, press the 3 car will be left, press 4 cars will turn right. in the other (0-9) key, car number control code display the corresponding number symbols. Press the power button, the car will stop running. Computer cart can also be used to send digital signals. The NIXIE tube displays the corresponding number (0-9). And perform
Platform: |
Size: 4096 |
Author: 黄林其 |
Hits:
Description: 基于51单片机的中断应用实例，能实现外部中断0和外部中断1的应用，通过led灯来显示效果-Interrupt application examples, based on 51 single chip microcomputer can realize the application of external interrupt 0 and external interrupt 1, through the led lights to show the effect
Platform: |
Size: 8192 |
Author: 金三角 |
Hits:
Description: 利用51单片机，外接一些LED灯，然后对灯的亮灭，顺序等进行操作，实现流水灯的效果-The use of 51 single-chip, an external number of LED lights, then the bright lights off, order, etc. to operate, to achieve the effect of water lights
Platform: |
Size: 1024 |
Author: 张三 |
Hits:
Description: LED显示屏的二次开发，案例例子,有实时显示屏更新数据，动态文本效果。-LED display of the two development, the case, there are real-time display update data, dynamic text effect.
Platform: |
Size: 851968 |
Author: Jenny |
Hits:
Description: LED跑馬燈實驗,利用左旋RLC、右旋RRC指令，讓8顆LED達到來回點亮、移動的效果。-LED Marquee experiment, the use of L-RLC, RRC instruction dextrose, reach back and forth so that eight LED lights, moving effect.
Platform: |
Size: 84992 |
Author: 林星宏 |
Hits:
Description: 超级简单呼吸灯方案设计，可以实现程序外led呼吸灯效果-Super simple breathing light design, the program can be implemented outside led breathing light effect
Platform: |
Size: 1445888 |
Author: 侯 |
Hits:
Description: 采用数组和指针的方法，实现led流水效果。-Adopt the method of array and pointer, the realization of the led water effect.
Platform: |
Size: 34816 |
Author: kevin pen |
Hits:
Description: 51单片机广告灯程序，效果是从八个LED灯的两端开始往中间流。-51 SCM advertising lights program, the effect is beginning to flow both ends to the middle eight LED lights.
Platform: |
Size: 48128 |
Author: 沙胡子 |
Hits:
Description: 基于51单片机的，摇摇棒显示“我爱你”的程序，根据点阵而设计的，通过控制led灯的亮和灭来达到显示一个字的效果，原理简单，程序短，适合嵌入式初学者-Based on 51 single-chip, shaking his stick shows " I love you" program, designed according to the lattice, led by controlling the bright lights and show off to achieve the effect of a word, the principle is simple, short program, suitable for embedded early scholar
Platform: |
Size: 2048 |
Author: TYT |
Hits:
Description: dsp定时器0测试程序，定时器计时到1000ms时，产生中断，进入中断服务子函数，改变电平，实现led灯闪烁效果-dsp test program Timer 0, timer counting to 1000ms, generate an interrupt, the interrupt service subroutine, changing the level, realize led lights flicker effect
Platform: |
Size: 478208 |
Author: 朱守文 |
Hits:
Description: 适用于S3C2410开发板的实现中断的裸板程序，用LED显示来反映效果。-Bare board S3C2410 development board suitable for the realization of interrupt program, with LED display to reflect the effect.
Platform: |
Size: 5120 |
Author: zd8899233kuibu |
Hits:
Description: 实验器材:探索者STM32F4开发板
实验目的:学习GPIO作为输出的使用
实验现象:本实验通过代码控制开发板上的两个LED：DS0和DS1交替闪烁，实现类似跑马灯的效果 -Experimental equipment: Explorers STM32F4 development board experiment: learning to use experimental phenomena as GPIO output: In this study, two LED code control development board: DS0 and DS1 flash alternately, to achieve a similar effect Marquee
Platform: |
Size: 2731008 |
Author: |
Hits:
Description: 本实验,利用外部中断，实现与实验3类似的效果，即：通过开发板上载有的4个按
钮（KEY_UP、KEY0、KEY1和KEY2），来控制板上的2个LED（DS0和DS1）和蜂鸣器
，其中WK_UP控制蜂鸣器，按一次叫，再按一次停；KEY2控制DS0，按一次亮，再按
一次灭；KEY1控制DS1，效果同KEY2；KEY0则同时控制DS0和DS1，按一次，他们的
状态就翻转一次。-In this study, the use of external interrupts, achieve a similar effect with Experiment 3, namely: The development board contained four buttons (KEY_UP, KEY0, KEY1 and KEY2), to control two LED board (DS0 and DS1) and buzzer, which WK_UP control the buzzer, press the call, press the stop KEY2 control DS0, press on, press off KEY1 control DS1, the same effect as KEY2 KEY0 the simultaneous control of DS0 and DS1, press once, their status will flip once.
Platform: |
Size: 124928 |
Author: |
Hits:
Description: 本实验,通过开发板上载有的4个按钮（KEY_UP、KEY0、KEY1和KEY2），来控制板
上的2个LED（DS0和DS1）和蜂鸣器，其中WK_UP控制蜂鸣器，按一次叫，再按一次
停；KEY2控制DS0，按一次亮，再按一次灭；KEY1控制DS1，效果同KEY2；KEY0则
同时控制DS0和DS1，按一次，他们的状态就翻转一次。 -In this study, by the development board contained four buttons (KEY_UP, KEY0, KEY1 and KEY2), to control two LED (DS0 and DS1) and buzzer board, which WK_UP control the buzzer, press the call press again to stop KEY2 control DS0, press on, press off KEY1 control DS1, the same effect as KEY2 KEY0 the simultaneous control of DS0 and DS1, press, their status will flip once.
Platform: |
Size: 122880 |
Author: |
Hits:
Description: Pixel Controller for RGB LED Controller V1A
Designed with ATMEGA8 Controller
Including WS2811, P9813, SM16276B and UCS1903.
Having Effect Selection,
Color Selection
Speed Selection
Chip Selection
No of LEDs Selection
Platform: |
Size: 52224 |
Author: shaikhameer |
Hits:
Description: Pixel Controller for RGB LED Controller V1B
Designed with ATMEGA8 Controller
Including WS2811, P9813, SM16276B and UCS1903.
Having Effect Selection,
Color Selection
Speed Selection
Chip Selection
No of LEDs Selection
Platform: |
Size: 52224 |
Author: shaikhameer |
Hits:
Description: STM32项目实战按键检测和LED控制例程功能实现代码,对于初学者来说，是有非常的帮助效果的-STM32 project combat key detection function and LED control routine implementation code, for beginners, it is very help effect
Platform: |
Size: 4812800 |
Author: 天下程序 |
Hits:
Description: 流水灯实例，8个LED循环点亮，实现流水灯效果-Example of water lights, 8 LED cycle lit, to achieve the effect of water lights
Platform: |
Size: 186368 |
Author: chi |
Hits:
Description: PubNub 是一家提供数据流网络及相关 API的企业，成立于 2010年，总部位于旧金山。原先 PubNub 的这个网络的主要客户是移动 app，透过后端平台的作用，让 app 内部可以进行通信。不过随着 IT 服务朝着 IP 网络的演进，以及物联网的日渐流行，使得 PubNub 逐步发展为一个安全可靠、遍布全球的的双向数据网络，成为为移动 app、web 以及物联网等依靠定期小型信令传输的服务的承载网。
目前 PubNub 拥有超过 2000 个客户，包括社交应用与消费者应用，以及金融、商业服务等垂直领域，但是物联网现在已成为 PubNub 发展最快和最大的业务。PubNub 的在网设备现已超过 2 亿的设备，每分钟要完成 2000 万个实时事务。我曾使用其它方式如 MQTT 来控制树莓派 GPIO 接口,而以 PubNub 的方式最简单。
以下网址范例在树莓派 3 执行 (树莓派2 也可以) 包含 2 部分, 首先手机透过浏览器接口将控制树莓派 led亮灭信号传至PubNub云端平台, 接着在树莓派执行应用程序(for python) 读取先前已存在 PubNub云端平台的 LED控制信号以控制GPIO 接口使得 LED 持续亮灭。
-PubNub is a provider of network traffic and related API company, founded in 2010 and headquartered in San Francisco. PubNub original main customers of this network is a mobile app, through the effect of the back-end platform, so app can communicate internally. But as the IT service evolution toward IP networks, as well as the growing popularity of things such PubNub progressive development of a safe, reliable, worldwide two-way data network, a mobile app, web and rely on things such as periodic small letter order bearer network transmission services. PubNub currently has more than 2000 customers, including social applications and consumer applications, and vertical areas of finance, business services, but now things have become PubNub fastest growing and largest business. PubNub in network equipment is now more than 200 million of equipment to complete the 20 million real-time transactions per minute. I have used other means such MQTT to control Raspberry Pi GPIO interfaces, and the ea
Platform: |
Size: 569344 |
Author: slim |
Hits: